11806-05-B vs 11807-20-L — Compare
Seymour Duncan TS-2s, Triple Shot, LP, Set, Black vs Seymour Duncan BMP-1 Bkouts Modular Pre Long Pot
The TS-2s is a passive switching system that adds tonal voicing options to existing humbuckers without electronics modification, while the BMP-1 is an active preamp that amplifies and conditions your signal for recording and live use. Choose the TS-2s if you want to unlock series/parallel/split tones from your current pickups; choose the BMP-1 if you need transparent gain, low noise, and active signal conditioning.
No sales tax on orders shipped outside California — total cost beats national retailers that charge sales tax in nearly every state.
Seymour Duncan TS-2s, Triple Shot, LP, Set, Black
Seymour Duncan BMP-1 Bkouts Modular Pre Long Pot
Specs side by side
| Seymour Duncan TS-2s, Triple Shot, LP, Set, Black | Seymour Duncan BMP-1 Bkouts Modular Pre Long Pot | |
|---|---|---|
| Price | $69.00 | $74.00 |
| Brand | Seymour Duncan | Seymour Duncan |
| Series | Seymour Duncan Electronics & Wiring | Seymour Duncan Electronics & Wiring |
| Condition | New | New |
Why choose Seymour Duncan TS-2s, Triple Shot, LP, Set, Black
- ✓ Three voicing modes (series, parallel, split) from existing humbuckers without routing or soldering
- ✓ Designed specifically for arched-top guitars like Les Pauls with integrated mounting ring
- ✓ Responsive on-ring switching accessible during play without reaching inside guitar body
- ✓ Budget-friendly tonal experimentation for intermediate to professional players
Why choose Seymour Duncan BMP-1 Bkouts Modular Pre Long Pot
- ✓ Active preamp topology delivers high output and low noise for studio and live recording
- ✓ Solderless bare-wire lockdown connectors eliminate solder joints and simplify installation
- ✓ Three additional 25k potentiometers let you customize tone controls to your exact setup
- ✓ Long-shaft potentiometer fits standard control cavities without modification
Frequently asked questions
Will these work with my Les Paul?
The TS-2s is built specifically for arched-top guitars like Les Pauls and mounts directly to existing humbucker cavities. The BMP-1 is a preamp system that works with any guitar architecture but requires integration into your control cavity.
Do I need to solder either of these?
The TS-2s requires four-conductor humbucker cables and standard wiring integration. The BMP-1 uses solderless bare-wire lockdown connectors, eliminating solder joints on pickup connections and volume control.
What's the main tonal difference?
The TS-2s gives you passive switching between series, parallel, and split voicings from your existing pickups for tonal flexibility. The BMP-1 provides active, transparent amplification with minimal noise, designed for studio recording and live performance where clean gain matters.
Which is better for studio recording?
The BMP-1 is purpose-built for studio recording with its high-output, low-noise preamp topology and customizable tone controls. The TS-2s is better for experimenting with different passive tones from existing pickups.